STEP 1—Take a 16 gauge wire and set it up as you see in Figure WB-1. First take a fishing swivel and secure it to the tailstock. (See a closer look at Figure WB-2.) Then string beads onto the wire. After you have done that, insert the wire into the chuck.

STEP 2—Go back to the instructions for wire-wrapping beads and stones. Wrap each bead with coils that are wrapped in-between each bead. When you get finished wrapping all of the beads, cut the overlay wire and remove the whole unit from the Gizmo by loosening the chuck and unwiring the tail from the fishing swivel. Clean up the ends where you have cut the overlay wire as discussed in previous instructions.

STEP 3—To finish this piece, you can either make an eye on each end and add a clasp that you have made or bought, or make a hook on one end and an eye on the other.